Tabletop to wall mount installation

Battery charging

Once you have installed the battery, the screen indicates the battery status (see the table below).

•For best performance, keep the handset in the telephone base or charger

when not in use.

•The battery is fully charged after 10 hours of continuous charging.

•If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays NO BATTERY.

Battery indicators		Battery status	Action

The screen is blank,		Battery has no or	Charge without interruption
or displays PLACE IN		very little charge. The	(about 30 minutes).
CHARGER and	flashes.	handset cannot be used.

The screen displays		Battery has enough	Charge without interruption
LOW BATTERY and		charge to be used for a	(about 30 minutes).
LOW BATTERY and		charge to be used for a	(about 30 minutes).
flashes.		short time.

The screen displays		Battery is charged.	To keep the battery charged,
HANDSET X.			place it in the telephone
			base or charger when not
			in use.

The telephone comes ready for tabletop use. Follow the steps below to mount your telephone on a wall.

. Plug one end of the telephone line cord into the TEL LINE jack at the bottom of the telephone base and the base power adapter into the POWER jack.

3.Route the telephone line cord through the hole on the wall mount bracket and plug it into the telephone wall jack. Route the power cord out of the telephone base and plug it into an electrical outlet not controlled by a wall switch.

2.Position the telephone base against the wall mount bracket as shown. Insert the extended tabs marked B on the wall mount bracket into the slots marked B on the back of the telephone base. Push the telephone base down until it clicks securely.

4.Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly with twist ties.