TURNING OFF THE
RINGER
PRESS
PRESS a
PRESS a
PRESS @
s- m,, | i:, j |
Checking The Ringer Type |
To test the present ringer type, do the following:
Press (m)or to exit.
CLR/DEL Key Function
be accessed separately depending on how long the key is held down. For example, to clear the last di it entered
on the display, presstheG&0 key for less than 1 second. Press and hold
Advanced Dialing ,J:~;;,'_+.
There are two different ways to d~al
anumber:
1.Press the (PHONE) key and wait for a dial tone. Then dial the number you want either manually, using MEMORY (MEM) dialing, CID dialing or REDIAL.
2.Enter the number you wish to dial on the display first. Then press the
(PHONE) key. This will dial the number which is displayed on the LCD after 2 seconds.
which is shown on the display.
',:. number
"cah 'bebhanaed bv:
Press and hold1-( until the display is cleared, then dial normally.
or
Press (OFF) and start over.
Storing Memory: (Speed) Dial 2,;;'.
numbers$!
To program a speed'dialidcation, do the following:
With the phone OFF, enter the telephone number you wish to store. (20 Digits Maximum).
Enter program mode by pressing (PROGS. The display will show the
following:
Enter the memorv location (01..20) you wish to store the number in. - As soon as the second memory location digit is entered, the unit will emit a happy tone (a short series of beeps) to confirm successful programming and exit program mode.
STORING SPEED DIAL
NUMBERS
DIALYOUR PHONE
NUMBER
PRESS @
PRESS LOCATION
:.i"';p.. p..i .'i' f..f i"'.
iY ! ii .i i 7Ci
I"': !.'.""'. .
iE..".I :""""':""
....... ' L....j.... ! i:::.
ii i : i
Unsuccessful programmingcan result from not correctly completing the programmingsequence. For example, if after entering a number on the LCD and entering program mode, t h e m key were pressed instead of entering a valid memory location, the
"PROGRAMMING INCOMPLETE" message would appear. If this message appears, simply repeat the programming sequence:
the )c( key for more than 1 second to completely clear the LCD.
The delete function is also used to delete CID and memory dial records, see DELETINGSTOREDNUMBERS, and DELETING NUMBERS.
