HALF-SIZE GAS CONVECTION OVENS - SERVICE PROCEDURES AND ADJUSTMENTS
17
DOOR ADJUSTMENTWARNING: UNPLUG UNIT BEFORE SERVICING.
1. The door should be parallel with the face of t he
oven cavity.
2. If adjustment is needed:
A. Remove the top front cover as outlined
under “COVERS AND PANELS” in
“REMOVAL AND REPLACEMENT OF
PARTS”.
B. Loosen the screws that secure the door
support and move the door in the slot until
it is parallel with the face of t he oven
cavity.
C. Tighten the screws and install the top front
cover.
BLOWER ADJUSTMENTWARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove rack and rack supports.
2. Remove baffle panel by l i fting up and out.
3. Check the blower. It should be ¼" away from
and parallel to the oven wall. If not, proceed to
step 4.
4. Remove the right side panel as outlined under
“COVERS AND PANELS”.
5. To adjust the blower at the sides (front and rear
of oven cavity), l oosen the motor mounting
bolts and move the motor until t he ¼" gap is
obtained.
6. To adjust the blower at the top and bottom,
place shims between the motor mounting
bracket and the mounting base.
7. Reverse the procedure to install.
HEATING ELEMENT TESTTest each rod in the element assembly.
Values in the table are nominal (± 10%).
VOLTAGE W ATTS AMPS RESISTANCE
208 2500 12 17.33
240 2500 10.4 23.1