Elite™ 400W Pro Pure Sine Inverter by Wagan Tech® | User’s |
|
|
TROUBLESHOOTING
PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason | Solution |
|
|
Poor contact with battery, inverter | Clean terminals thoroughly. Reinstall |
terminals, or DC socket. | and tighten. Clean DC socket with non- |
| metallic abrasive emery stick. |
|
|
PROBLEM: No Output Voltage – No LEDs Lit | |
|
|
Reason | Solution |
|
|
Blown fuse. | Check vehicle’s Accessory Socket Fuse. |
| If the fuse is blown, replace with the |
| same type and rating fuse. |
|
|
PROBLEM: Inverter Auto Shut Down – Fault LED Lit | |
|
|
Reason | Solution |
|
|
Battery voltage is below 9.5 volts. | Charge or replace battery. |
|
|
Inverter is too hot (thermal shut down | Allow inverter to cool. |
mode). | Check for adequate ventilation. |
| |
| Reduce the load on the inverter to |
| the specified TrueRated™ power max |
| output. |
|
|
PROBLEM: Inverter Shut Down – Fault LED Lit
Reason | Solution |
|
|
Equipment being operated draws too | Do not use the equipment with this |
much power. | inverter; use a higher wattage inverter. |
|
|
PROBLEM: Continuous Buzzing Sound |
|
|
|
Reason | Solution |
|
|
Input voltage is below 10.5 volts . | Keep input voltage above 10.5 volts . |
|
|
Poor or weak battery condition. | Recharge or replace battery. |
|
|
Poor or loose cable connection. | Inspect terminals and tighten all |
| connections. |
|
|
Inadequate power being delivered to | Use heavier gauge DC cables. |
the inverter or excessive voltage drop. | Keep cable length as short as possible. |
| |
|
|
DISPOSAL/RECYCLING OF INVERTER
Electronic products are known to contain materials that are toxic if improperly disposed. Contact local authorities for disposal and recycling information.
©2012 Wagan Corporation. All Rights Reserved.
9
www.wagan.com
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
10
