Wagner SprayTech HIGH PERFORMANCE AIRLESS SPRAYER Cleaning the Spray GUN Filter and TIP Assembly

CLEANUP (CONTINUED)

CLEANING THE SPRAY GUN FILTER AND TIP ASSEMBLY

1.Make sure the pump is switched OFF (O), the PRIME/SPRAY knob is turned to PRIME, and unplug the sprayer.

2.Remove spray gun from the paint hose using adjustable wrenches.

3.Remove filter from spray gun (refer to Cleaning the Spray Gun Filter, page 9).

GX-08/10

Housing

GX-06/07 Filter

Filter

Spring

Trigger

guard

FittingHousing

4. Remove spray tip from spray guard assembly.

5Clean spray tip and filter with a soft-bristled brush and the appropriate cleaning solution. Be sure to remove and clean the washer and saddle seat located in the rear of the spray tip assembly.

Saddle Washer seat

6. Reassemble spray gun:

• install gun filter tapered-end first, and

GX-08/10

Housing

GX-06/07 Filter

Filter

Spring

Trigger

guard

Fitting

Housing

•install spray tip, saddle seat and washer, and replace spray guard assembly.

7.Thread the spray gun back onto the paint hose. Tighten with a wrench.

Continue cleaning instructions on next column

IMPORTANT!

If you used oil-based paints, you must flush the pump again using warm, soapy water to prepare it for storage. Repeat Cleaning the Suction Set instructions.

© 2002 Wagner Spray Tech - All rights reserved. 11 Customer Service: 800-686-8525 English