SETUP--ASSEMBLING THE SPRAYER
TOOLS NEEDED FOR SETUP
•Two adjustable wrenches
•3/16” allen wrench
•Extension cord (refer to Important Electrical Information (page 3).
WARNING
Do not plug in the unit until setup is complete.
ATTACHING THE HANDLE (CART MODEL)
1. Position the handle against the cart so that the holes in the handle line up with the holes in the cart.
2. Insert the bolts through the holes in the handle and cart and locking washers.
3.Tighten the wing nuts onto the bolts by hand.
ATTACHING THE HOSE BRACKET (CART MODEL)
1.Insert the ends of the hose bracket into the holes of the handle as
shown.
ATTACHING THE PAIL BRACKET (CART MODEL)
1. Position the pail bracket against the unit so that
ATTACHING THE SPRAY GUN
1. Thread spray gun onto the other end of the hose.
Hold the gun with one adjustable wrench, and tighten with the other.
ATTACHING THE SUCTION SET & RETURN TUBE
1.Attach the suction tube to the inlet valve and tighten firmly by hand. Be sure that the threads are straight so that the fitting turns freely.
2.Press the return tube onto the return tube fitting.
3.Squeeze clip over the return tube fitting to secure return tube.
Return tube
fitting
Inlet valve
Clip
Return tube
Suction set
LOCKING AND UNLOCKING THE SPRAY GUN
WARNING
Always lock the trigger off when attaching the spray tip or when the spray gun is not in use. Refer to Spray Gun/Tip Chart on page 4 to determine the gun model you have.
the holes in the unit line up with the holes in the bracket.
2. Insert the bolts through the holes in the bracket and the unit.
3. Tighten the bolts with a 3/16” allen wrench.
AP H
GUN MODELS
GX-07
The gun is secured when the trigger lock is at a 90° angle (perpendicular) to the trigger in either direction.
GX-06/07
Gun locked (gun will not spray)
TTACHING THE AINT OSE
1.Thread the high pressure hose to the paint hose port.
2.Tighten with an adjustable wrench.
3. Remove pusher stem from inlet valve.
GX-08/10
Gun locked
(gun will not spray)
GUN MODELS
GX-10
To lock the gun, turn the trigger lock forward and slightly down until it stops.
The spray tip SHOULD NOT be attached until after the sprayer and paint hose have been purged and primed.
© 2002 Wagner Spray Tech - All rights reserved. | 5 | Customer Service: | English |
