Walker MT owner manual Operating Instructions, Correct Operator Hand Position on the Controls

Operating Instructions

Pull Steering

Levers With

Left Hand

Forward Speed Control

(FSC)

Keep Feet On Footrest

When Moving

Correct Operator Hand Position

on the Controls

3.Reverse direction of the mower by pulling both levers backward.

NOTE: Smooth action on the steering levers will produce smooth mower operation. Remem- ber to keep the engine and ground speed slow until learning the control response.

4.The FSC may be adjusted forward for faster ground speed and backward for slower ground speed. When mowing, ground speed should be adjusted to match the load on the cutter blades, i.e., as the engine pulls down in heavy cutting, pull back on the FSC lever to reduce ground speed. Adjusting ground speed helps maintain a balance between engine power and blade speed for high-quality cutting action.

5.Stop ground travel by pulling both steering le- vers backward to the NEUTRAL position (trac- tor not moving) and then moving the FSC lever to the NEUTRAL-PARKposition.

NOTE: If the tractor creeps forward or back- ward with the FSC lever in the NEUTRAL-PARKposition, the transmission control needs to be adjusted. Refer to ADJUSTMENTS of Trans- mission Control in Maintenance Instructions.

ENGAGING THE MOWER

1.Set the engine throttle at about 1/3 speed. Do not attempt to engage the blade clutch at high engine speeds. This will drastically short- en drive belt life. Use only moderate engine speed when engaging the blade clutch.

2.Pull the blade clutch lever SLOWLY up to en- gage the mower blades.

CAUTION

A safety interlock switch (seat switch) will cause the engine to stop if the blade clutch is engaged and the operator is not in the seat. The function of this switch should be checked by the operator rais- ing off the seat and engaging the blade clutch; the engine should stop. If the switch is not working, it should be re- paired or replaced before operating the mower. DO NOT disconnect the safety switches; they are for the operator’s pro- tection.

IMPORTANT: DO NOT engage the blade clutch when transporting the mower across drives, side- walks, loose materials, etc. DO NOT engage the

blade clutch with the PTO shaft disconnected (the mower deck removed from tractor).

CAUTION

If the cutting blades strike a stationary ob- ject while mowing, stop the mower imme- diately, disconnect the spark plug wires, lift the deck, and inspect the deck and blades thoroughly for damage. Make sure that the blade timing has not been dis- turbed (the blades should be at 90 degrees to each other). Refer to REPLACING/RE- PAIRING the Blade Overload Shear Bolts in Maintenance Instructions if blades are out of time. Also, make sure the blade retain- ing nuts are torqued to 60 ft-lb (81.3 N⋅m).

32