Warwick 3.3 / 5.2 owner manual Front Panel Controls, Profet

REAR PANEL

FRONT PANEL CONTROLS

INPUT

GAIN COMPRESSOR CONTOUR

BASS

LOW MID

HIGH MID

TREBLE

DEEP

BRIGHT

MASTER

MUTE

PHONES

POWER MAINS IN AC GROUNDLIFT

TUNER OUT

LINE OUT

EFF. LOOP

DI PRE/POST DI OUT

SPEAKER OUT

Socket to plug in a bass guitar.
Control + CLIP LED to adjust the input level.
Switch to activate the compressor control to adjust the level of compression.
Switch to activate the contour control to adjust the level of the contour
(bass- and treble boost and mid cut)
Control to boost/cut deep frequencies.
Control to boost/cut low mids.
Control to boost/cut high mids.
Control to boost/cut high frequencies.	5.1
Control to boost/cut high mids.
Control to boost/cut high frequencies.
Control determines the mains level.
Switch + ON/MUTE LED cuts the signal from all outputs, except from the PHONES socket and leads
the signal to the TUNER OUT socket.
Socket for connecting a headphone (min 200 Ω).
	PROFET
Switch for turning the amplifier on and off.

Terminal with integrated fuse compartment for connecting the amplifier to the current network. Switch isolates the earth connection from the ground of the signal. Should several devices be simul taneously connected to earth by the same conductor as well as via line connections, a so called hum loop might appear. In this case operate GROUND LIFT to eliminate the current hum (when pressed). Socket for the connection of a tuner. When MUTE mode is activated, the unmodified bass signal is retained here.

Socket allows to connect additional power amplifiers or active cabinets.

For the insertion of effects units. Connect SEND with the input and RETURN with the output of the effects device.

Switches the signal lying at the DI OUT socket.

Socket, PRE (pressed) unmodified bass signal, or POST (unpressed) bass signal treated by the tone controls ans possibly by connected effect devices.

Socket for connecting the loudspeaker.

9