Warwick 3.3 / 5.2 owner manual Rear Panel, Profet, Front Panel Controls

FRONT PANEL CONTROLS

	INPUT	Socket to plug in a bass guitar.
	GAIN	Control + CLIP LED to adjust the input level.
	COMPRESSOR	Switch to activate the compressor control to adjust the level of compression.
	CONTOUR	Switch to activate the contour control to adjust the level of the contour
		(bass- and treble boost and mid cut)
	BASS	Control to boost/cut deep frequencies.
	LOW MID	Control to boost/cut low mids.
	HIGH MID	Control to boost/cut high mids.
	TREBLE	Control to boost/cut high frequencies.
	DEEP	Control to boost/cut high mids.
	BRIGHT	Control to boost/cut high frequencies.
3.2		Control determines the mains level.
	MASTER
	MUTE	Switch + ON/MUTE LED cuts the signal from all outputs, except from the PHONES socket and leads
		the signal to the TUNER OUT socket.
	PHONES	Socket for connecting a headphone (min 200 Ω).
	REAR PANEL
PROFET		Switch for turning the amplifier on and off.
	POWER
	MAINS IN AC	Terminal with integrated fuse compartment for connecting the amplifier to the current network.
	GROUNDLIFT	Switch isolates the earth connection from the ground of the signal. Should several devices be simul
		taneously connected to earth by the same conductor as well as via line connections, a so called hum
		loop might appear. In this case operate GROUND LIFT to eliminate the current hum (when pressed).
	TUNER OUT	Socket for the connection of a tuner. When MUTE mode is activated, the unmodified bass signal is
		retained here.
	LINE OUT	Socket allows to connect additional power amplifiers or active cabinets.
	EFF. LOOP	For the insertion of effects units. Connect SEND with the input and RETURN with the output of the
		effects device.
	DI PRE/POST	Switches the signal lying at the DI OUT socket.
	DI OUT	Socket, PRE (pressed) unmodified bass signal, or POST (unpressed) bass signal treated by the tone
		controls ans possibly by connected effect devices.
	SPEAKER OUT	Socket for connecting the loudspeaker.

10