Warwick CCL 210 ND 8, CCL ND 4, CCL ND 8 owner manual Ccl

FRONT PANEL CONTROLS (CCL ND 8 - CCL 210 ND 8)

INPUT	socket to plug in a bass guitar.
GAIN	control + CLIP / LIMIT LED to adjust the input level.		ND
LIMITER	switch + 2-colored CLIP / LIMIT LED to compress the signal within the preamp.
LOW BOOST	switch + LED to boost the low end.
BASS	control to boost / cut low frequencies.
PUNCH	control for boosting/cutting deep mids.
MID FREQ.	control to determine the midrange frequency.
MID LEVEL	control to boost / cut the frequency adjusted with the MID FREQ. control.
ATTACK	control for boosting/cutting high mids.
TREBLE	control to boost / cut high frequencies.
HIGH BOOST	switch + LED to boost the highs.
MUTE	switch + ON / MUTE LED mutes the signal of all outputs except the PHONES and TUNER socket. To avoid
MASTER	switching noise use the MUTE switch only while no audio signal is being played back.		CCL
	control determines the main volume level.
PHONES	socket for connecting headphones (min 200 Ohm).
REAR PANEL (CCL ND 8 - CCL 210 ND 8)
MAINS IN AC		terminal with integrated fuse compartment for connecting the amplifier to mains.
POWER		switch for turning the amplifier on and off.
GROUNDLIFT		switch disconnects the protective ground line from signal ground. A humming loop may occur when
		several devices are hooked up to the same protective ground line and connected by line cables. Use
TUNER OUT		GROUNDLIFT to eliminate humming loops.
		to connect to a tuner, active when MUTE is enabled.
LINE OUT		socket allows connecting additional power amplifiers or active cabinets.
EFF. LOOP		for the insertion of an effects unit. Connect EFF. SEND with the input and EFF. RETURN with the output
DI PRE / POST		of the effects device.
		switch to route the signal to
DI OUT		socket PRE (pressed, direct signal from the bass) or POST (released, signal affected by equalizer or
SUBSONIC		effects loop). Symmetric XLR out to connect to e.g. a mixing console.	ENGLISH
		switch to cut low frequencies from the power amp (CCL ND: signals below 120 Hz).
SPEAKER OUT EXT. to connect an additional speaker with min 8 Ohm.
SPEAKER OUT		to connect the amplifier to the speaker.
HORN ATT.		to control horn volume separately.
Retractable handle and wheels make it easy to transport your Warwick Combo.

9