Wasp Bar Code CCD Scanner

Appendix A

BARCODE TEST SYMBOLS

UPC-A*

UPC-E*

UPC-E

w/5 digit supplement

UPC-E

w/2 digit supplement

UPC-A

w/2 digit supplement

UPC-A

w/5 digit supplement

*Default

WCS3900_3905Manual0707_sm.A0 6/25/08 4:32 PM Page 30

Contents

Main CCD Scanner Programming Guide Please Read Note: Tech Tip Wasp Barcode Technologies Table of Contents Chapter 1 Introduction Chapter 2 Barcode Symbologies Chapter 3 Installation WCS3900 USB Scanner WCS3900 PS2 Scanner Chapter 4 Quick Start PS2 Connection USB Connection Setup & Configuration In order to configure Wasp WCS3900 Series Scanners, two basic steps need to be followed: To change Minimum/Maximum Length: Example: Page BEEP AND DELAY Beep Settings BEEP AND DELAY Interblock Delay Intercharacter Delay UPPER/LOWER CASE Page PREAMBLE/POSTAMBLE CONFIGURATION TERMINATOR/CODE ID Terminator Code ID ENABLE/DISABLE BARCODE SYMBOLOGIES Enable Disable ENABLE/DISABLE BARCODE SYMBOLOGIES Enable Disable CODE 39 SETTINGS INTERLEAVED 2 OF 5 AND CODE 93 SETTINGS CODE 128 AND UCC/EAN 128 SETTINGS To Define UCC/EAN 128 Group Separator: Note: MSI PLESSEY SETTINGS CODABAR SETTINGS UPC-A SETTINGS UPC-A SUPPLEMENT SETTINGS / UPC-A TO EAN-13 This option expands the UPC-A barcode to EAN-13. UPC-E SETTINGS UPC-E SUPPLEMENT SETTINGS EAN-8 SETTINGS EAN-8 SUPPLEMENT SETTINGS EAN-13 SETTINGS EAN-13 SUPPLEMENT SETTINGS Page Page Page Page Page PostScript Picture (G.eps) Page Appendix C Appendix D Warranty Information FAQ 38 39 Page CCD Scanner Programming Guide Please Read Note: Tech Tip Wasp Barcode Technologies