
6. Get Familiar with the Keyboard
Press [CMD] plus the desired function key (located near the bottom of the keypad) to perform commands F5 through F8 or to input special characters that appear in yellow on some keys.
Press [ALPHA] to toggle between Numeric (block cursor) and Alphabetic (underscore cursor) entry modes. Characters are selected by quickly pressing a key one, two or three times.
Press [SP] to input a space (blank) character.
In Command or Supervisor mode, press [ESC] to return to the previous menu.
In Numeric or Alphabetic Mode, press [C] to clear the last character entered (backspace).
Use [ENT] as an Enter key to terminate entry of text, for example.
When an application has enabled the
7.Learn to Navigate the Modes
Beginning with the WDT2200 powered off,
press and hold these three keys in the sequence shown to get to the Start Menu:
<<START MENU >> 1.SUPERVISOR 2.WARM START 3.COLD START
Press the [1] key at the Start Menu, then supply the default password “2200” and press [ENT] to access Supervisor Mode:
1.DEV 2.TERM 3.MEM 4.FORM 5.PWR 6.PSWD 7.SYS 8.DIAG
The Supervisor Menu allows access to Language, baud rate, and barcode symbology selection as well as Form Caching and functions. Press the [ESC] key to exit to the Ready Mode:
WDT2200 v1.10 MEM 2560 KB
>
In Ready Mode, press and hold the [CMD] key for two seconds to enter User Mode:
1.RUN 2.TER 3.COM 4.DIR 5.ERA 6.TYP 7.CPY 8.SET
See p. 15 of the WDT2200 User Reference Guide on the CD in the docs folder for more information on User Mode. Press [ESC] to exit, then turn off the unit.
You are now ready to install and use Wasp’s AppGen Pro software. Insert the AppGen
WDT2200
Quick Start
Guide
© 2003 Wasp Technologies, Inc.