![](/images/new-backgrounds/1263918/2639183x1.webp)
7 Steps for Getting Started with the WDT2200
1. Remove the Lens Protectors
Remove the protective films from the LCD display and the scanner lens. This film can interfere with barcode scanning.
2. Open the Battery Compartment
Remove the battery door from the rear of the WDT2200 by turning the screw on the battery cover counterclockwise.
Data loss will occur if you remove the CR2032 Lithium backup battery that resides in the lower compartment.
This battery does not have to be replaced until prompted by a warning message. If you see a transparent film insulating the backup battery, please remove it now.
3. Install the Main Battery
Insert the rechargeable Lithium Ion battery pack into the main battery chamber, sliding the end with two protruding terminals into position first.
Reinstall the battery door and tighten the screw by turning it clockwise.
4.Connect the Communications Cable and Charge the Main Battery
Connect the cable’s
•If you have a communications / charging cradle for the WDT2200:
Place the WDT2200 in the cradle to begin the charging cycle. When the red LED turns green, the battery is fully charged. (Note: The LED on the cable itself is always green when powered and connected to a cradle.)
•If your WDT2200 is not equipped with a cradle:
Attach the cable directly to the WDT2200. The cable’s LED will be red while charging, then green when the battery is fully charged.
Charging will require 2 to 3 hours.
5. Power on the WDT2200
Press the red and white power key to turn on the WDT2200. (Note: To turn the unit off, press and hold the power key for about one second.)