Water Pik Technologies, Inc. | Page 3 | |
|
|
|
6.If the pump(s) is on: put your hand over the hole in the back of the cleaner and force the water back into the cleaner. Use the whip hose to further remove any debris.
7.If the pump(s) is off: use a garden hose to remove debris.
8.Make sure all moving parts are free of debris. Install the screen and debris compartment. Place the
SECTION 5.
Remove
5A. Quick Disconnect
1.At the equipment pad, turn off all pool pumps.
2.Grasp the Quick Disconnect Coupler and turn it counterclockwise ¼ turn.
3.Pull out and remove hoses from pool.
4.To reinstall, align tabs on Quick Disconnect Coupler in the Wall Reducer.
5.To lock, turn the Quick Disconnect Coupler ¼ turn clockwise, then give a gentle pull on the hose to seat the Quick Disconnect Coupler.
Figure 5. Check Debris Compartment Door
SECTION 4.
Skimmer Guard
4A. Skimmer Guard Installation
1.Insert the Skimmer Guard into the center of the skimmer opening about 1" from the wall edge.
Figure 7. Remove Quick Disconnect
2.Begin turning the top half of the skimmer guard clockwise while holding the bottom half until you see the guard expanding in length.
3.Continue turning until the guard expands to fit tightly between the top and bottom of the skimmer opening.
Skimmer | Skimmer |
Guard | Opening |
Figure 6. Skimmer Guard