AquaLink® RS TeleLink Telephone Interface
Installation Instructions- Jandy part #6590
! Caution
Do not mount the TeleLink PCB in the
AquaLink Power Center. Keep in original
TeleLink enclosure.
AquaLink® RS
TeleLink Board
re d b la c k y e llo w g re e n
|
|
|
|
|
|
| To RS485 | Phone Cable |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| from Wall Jack. | |
|
|
|
|
|
|
| Cable |
|
1 |
| 2 |
|
|
| |||
|
|
| (C able between |
| ||||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Controller and |
|
Program |
|
| Program | Power Center) |
| |||
# of rings |
|
| access code |
|
| |||
(default: 4) |
|
| (default: 62) |
|
|
The TeleLink enclosure will need to be installed as close as possible to a phone jack to keep the phone cord as short as possible between the phone and the TeleLink. The TeleLink will need the phone cord to communicate with the house phone. Run the
NOTE: If you are installing more than one accessory board, order and use a Jandy Multiplex PCB Kit, (p/n 6584). Never put more than two wires into each of the pins of the red terminal bar. Use the Multiplex PCB whenever more than two of the
6000 Condor Drive, Moorpark, CA, USA 93021 • 707.776.8200 FAX 707.763.7785 480 S. Service Road West, Oakville, Ontario, Canada L6K 2H4 • 905.844.8233 FAX 905.844.2635
Litho in U.S.A. © Water Pik Technologies, Inc. 2001
Sheet # 6862 Rev. E, 1/01 | For Technical Support call |