Waterpik Technologies TRS-553 instruction manual Components, Operation, Troubleshooting Guide

2 In 1 Shower System

Sistema de ducha 2 en 1

Instruction Manual

Manual de Instrucciones

Models:

JP-120 and NML-659 Combo

TRS-523 and TRS-553 Combo

Modelos:

JP-120 y NML-659 Combinado

TRS-523 y TRS-223 Combinado

Actual product may not match that shown.

El producto real puede ser diferente del modelo que se muestra.

COMPONENTS

Your showerhead comes with the respective hardware set shown below.

Waterpik® brand showerheads are equipped with an OptiFlow® regulator that limits maximum water flow to 2.5 gallons per minute at 80 psi as mandated by U.S. federal law.

Flow regulator

Hand-held bracket

Diverter

Filter screen

Flow regulator

Vacuum breaker (some models)

COMBO SYSTEM INSTALLATION INSTRUCTIONS

1)Remove old showerhead from shower arm. Clean shower arm pipe threads thoroughly.

2)Attach diverter valve by threading clockwise onto shower arm with diverter bracket facing right.

3)Attach wall mount showerhead to front-facing end of diverter.

4)Attach one end of the hose to hand shower and the other end to the bottom of the diverter.

5)Point all showerheads away from you and turn on the water full force. Check for leaks. Re-tighten all attachments if necessary.

OPERATION

1)Spray pattern is controlled by outside trim ring.

2)To change between the hand-held or fixed mount spray, turn the tabs on the diverter clockwise or counter clockwise.

TROUBLESHOOTING GUIDE

Problem	Solution
No water flow from installed	a  Confirm previous shower washer is not in the
shower head:	j-pipe.
	b  Confirm the hose is properly installed, try
	switching ends.
	c  Confirm there is only one washer in the pivot
	ball.
Low water pressure or	a  Clean shower head in vinegar/water solution.
missing spray patterns	(See care section).
	b  Clean screen and flow regulator.
Leaking at pipe pivot ball	a  Confirm one single washer is seated on top of
connection:	the screen.
	b  Grate bar of soap across the j-pipe threads to
	act as a sealant.
Showerhead and/or bracket	a  Immerse pivot ball and large nut of the bracket
stiff to change angle	in hot water or use a blow dryer for several
	minutes and then use a towel to loosen the
	large nut.
	For Fixed Mount: install FM shower head to
	provide additional leverage to change angle of
	spray. (Contact Waterpik for further assistance).

CARE AND CLEANING

Polish with moist, soft cloth. For heavier cleaning, submerge in household vinegar. If other cleansers contact product, rinse immediately.

NOTE

Vacuum Breaker

The state of Wisconsin and the City and County of Los Angeles, California, U.S.A. require vacuum breakers on all hand-held showerheads. Vacuum breakers are required by certain plumbing codes in order to protect water supplies from potential back-flow.

Installation

The vacuum breaker is located on the end of the hose. Hand tighten the vacuum breaker clockwise onto the bracket. DO NOT ATTACH VACUUM BREAKER TO SHOWERHEAD. This would stop the flow of water.

LIMITED LIFETIME WARRANTY

Water Pik, Inc. warrants to the original purchaser of this product that it is free from defects in material and workmanship for as long as the original purchaser owns this product. Water Pik will replace any part of the product, which in our opinion is defective, provided that the product has not been abused, misused, altered or damaged after purchase. (This includes damage due to use of tools or harsh chemicals). In the event an item has been discontinued, we will replace with what we deem to be the closest product. Water Pik is not responsible for labor charges, installation, or other consequential cost. The responsibility of Water Pik shall not exceed the original purchase price of the product.

This warranty gives you specific legal rights. You may also have other rights that vary where you reside. Save your receipt, as proof of purchase is required for warranty action.

Have questions or need assistance?

Visit www.waterpik.com

or call for Customer Service at 1-800-525-2774

8:00 a.m. to 4:00 p.m.,

Mountain Standard Time, Monday-Friday

Water Pik, Inc.

1730 East Prospect Road Fort Collins, CO 80553-0001

FN 20009959-F AC

Waterpik® (stylized) is a trademark of Water Pik, Inc. registered in the EU, Switzerland, Mexico, Canada, and United States.

Waterpik® is a trademark of Water Pik, Inc. registered in Argentina, Australia, Austria, Canada, China, Czech Republic, Hungary, India, Japan, Poland, Russian Federation, South Africa, Switzerland, Ukraine, and the United States.

OptiFlow® is a trademark of Water Pik, Inc. registered in Australia, Canada, the EU, Korea and the United States.

© 2010 Water Pik, Inc.  Printed in China.  Made in China.

DATE: 21 May 2010    CLIENT: Water Pik, Inc.

FILENAME: FN20009959-FAC_ComboInst.indd		DESCRIPTION: 2 in 1 Shower System Instruction Manual
FILE TYPE: Adobe InDesign CS4		PREPARED BY: Brian Colon		FORM: 20009959-F AC
SIZE FLAT: 11” x 8.5”	SIZE FOLDED: 3.6875” x 4.25”			FOLDS: Indicated.
DIELINE: N/A			INK: Black
NOTES: