Wayne-Dalton 260597, 260600 Outside Lock Handle Assembly, Inside Handle Assembly, Fig

Step 2: Outside Lock Handle Assembly

8000/PR9000 & PR9050 Series doors (see Fig. 4),

align the outside handle assembly with the handle point- ing towards the floor and insert the assembly through the previously drilled 3/4” diameter holes in the section. Secure the outside lock handle to the section with (2) #10 phillips head screws.

9000 Series & Wood doors (see Fig. 5), align the out- side handle assembly with the handle pointing towards the floor and insert the assembly through the previously drilled 3/4” diameter holes in the section. With the outside lock placed in the section, place the center lock stile over the shank of the outside lock handle, secure the center lock stile with foam tape (8300/8500 Series

&Wood doors will use the lock backup plate with no foam tape). Secure the outside lock handle to the sec- tion by placing the (2) #10 phillips head machine screws through the lock stile into the lock section. NOTE:

Before proceeding to the next step its recommended that the outside handle be locked.

Step 3: Inside Handle Assembly

8000/8100/8200 & 9000 Series doors (see Fig.6), po-

3/4” DIA.
HOLES
OUTSIDE
HANDLE
HANDLE
SHANK
Fig. 4	#10 PHILLIPS
	HEAD SCREWS
FOAM TAPE		HANDLE
		SHANK
OUTSIDE
HANDLE		CENTER
		STILE

3/4” DIA.

HOLES

#10 PHILLIPS HEAD SCREWS

Fig. 5

PRE-PUNCHED

sition the inside handle over the shank of the outside handle, flush against the center stile. Align the holes in the handle with the pre-punched holes in the center stile, then turn the handle clockwise to secure with (2) #8 screws.

HOLES

HANDLE

8300/8500 Series & Wood doors ( see Fig.7), position the inside handle over the shank of the outside handle, flush against the lock backup plate. Align the holes in the handle with the pre-punched holes in the lock backup plate, then turn the handle clockwise to secure with (2) #8 screws.

NOTE: When securing the inside handle bracket, be sure not to over tighten the screws or damage to the inside handle may occur.

NOTE: Follow the Main Installation Instruction Manual to install the door sections and vertical track before you install the remainder of the lock parts. After the sections and track are installed, continue with Step 4.

3

SHANK
INSIDE
HANDLE CENTER
STILE	(2) #8 SCREWS

Fig. 6

BACKUP PLATE

PRE-PUNCHED

HOLES

SHANK

HANDLE

INSIDE	(2) #8 SCREWS
HANDLE

Fig. 7