Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,
refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
WARNINg WARNINg

kEEP HORIzONTAL TRACk PARALLEL AND WITHIN 3/4” TO 7/8” MAxIMuM

OF DOOR EDgE, OTHERWISE DOOR COuLD FALL, RESuLTINg IN SEvERE OR

FATAL INJuRy.

IMPORTANT: DO NOT SUPPORT THE WEIGHT OF THE DOOR ON ANY PART OF THE HORI-
zONTAL TRACK HANGER THAT CANTILEVERS 4” OR MORE BEYOND A SOUND FRAMING
MEMBER.
NOTE: If rear back hangs are to be installed over drywall, use (2) 5/16” x 2” hex head lag
screws and make sure lag screws engage into solid structural lumber.
NOTE: 26” angle must be attached to sound framing members and nails should not be used.
Now, permanently attach the weatherstrips on both door jambs and header. The weather-
strips were temporarily attached in Preparing the Opening, in the pre-installation section of
this manual.
NOTE: When permanently attaching the weatherstrips to the jambs, avoid pushing the weath-
erstrips too tightly against the face of door.
Vice clamp
Horizontal tracks
2nd Track roller
Vice clamp

5/16”-18 x 1-1/4”

Hex bolt must extend into the

track to serve as a roller stop

Perforated angle
Sound framing
members
Horizontal
track
(3) 5/16” Bolts and nuts

Perforated angle bolted

using (2) 5/16” x 1-5/8”

hex head lag screws to

ceiling member and

parallel to door

Perforated angle
Sound framing
members
Horizontal
track
(3) 5/16”
Bolts and nuts
Perforated angle bolted
using (2) 5/16” x 1-5/8”
hex head lag screws to
ceiling member and
parallel to door
5/16”-18 x 1-1/4”
Hex bolt must extend into the
track to serve as a roller stop
Horizontal tracks
Door edges
3/4” To 7/8”
3/4” To 7/8”
Attaching Front Cable Lift Sheaves
Tools: 3/8” Wrench
19
Using (1) 3/8”-16 hex nut, attach the front cable lift sheave in the appropriate hole (left hand
shown).
IF yOu HAvE 3” FRONT CABLE LIFT SHEAvE AND A 12” RADIuS HORIzONTAL TRACk:
Bolt the front cable lift sheave to the 13/32” hole near the top of the flag angle, as shown.
IF yOu HAvE 3” OR 4” FRONT CABLE LIFT SHEAvE AND A 15” RADIuS HORIzONTAL
TRACk:
Bolt the front cable lift sheave to the first 13/32” hole in the horizontal angle, as shown.
Repeat for other side.
Remove the locking pliers from the vertical tracks. With assistance, raise the door slowly into
the open position making sure the door travels smoothly through the tracks. Clamp locking
pliers to the back leg of both horizontal tracks, below the bottom track rollers to keep the
door from lowering.
Flag angle Front
cable lift
sheave
3/8 - 16”
Hex Nut
Horizontal
Angle
15” Radius horizontal
track with 3” or 4”
front cable lift sheave
hole location
12” Radius
horizontal track with
3” front cable lift
sheave hole location
10