Wayne-Dalton HA14WD user manual Important Warnings and Safety Instructions

Glossary/Warnings/Table of Contents

2

Table of Contents
Introduction and Z-Wave® Home Control Basics	1
Table of Contents	2
Warnings and Glossary	2
Installation	3-5
Programming/Operation/Troubleshooting	5
Technical Specifications/Compliance	6

Warning

IMPORTANT WARNINGS and SAFETY INSTRUCTIONS

1.Heed all warnings.

2.Read and follow these instructions

3. Keep these instructions for future reference.

4. If you are unsure about any part of these instructions, consult a qualified electrician or use a qualified electrician for this installation.

5. Use this device only with copper or copper clad wire.

6.3-Way switch applications may require an additional wire to be run, refer to the wiring diagrams for further instruction.

7.To reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance, a fluorescent lighting fixture, or a transformer supplied appliance.

GLOSSARY

Copy – See Replicate.

Delete – Erase transmitter or scene information from Controller. Also known as Exclude. Device – Any item that is connected to a module (for example, lamps).

Exclude – Remove a module, transmitter or scene from the controller. Include – Add a module to the controller. Also known as Inclusion.

Module – Any Wayne-Dalton or Z-Wave®product that is controlled with a Wayne-Dalton or Z-Wave®remote controller. A module can be part of more than one scene.

Network – A collection of Z-Wave®modules controlled by primary and secondary controllers operating on the same system. A network has its own unique identification code so that no one else can control the system.

Node – Single Z-Wave®endpoint (controller or module) on a network .

Primary Controller – The first controller used to set up your modules and network.

NOTE: Only the Primary Controller can be used to include or delete modules from a network. It is recommended that you mark the primary controller for each network for ease in modifying your network.

Replicate – Copy from one controller to another.

Scene – A scene is a series of Z-Wave®modules programmed to turn to a specific level (on, off or dim, normal mode, save mode, etc...) with the push of a button on a controller.

Schedule - A timer based event in the software that will activate a scene or turn on/off a zone at a specified time of day, or at sunrise or sunset.

Secondary Controller – A controller containing network information about other modules within the network, and is created FROM the primary controller. Secondary controllers cannot include or delete modules to the network.