Installation (continued)
10.Test switch by pressing the upper part of the rocker switch to turn the lights ON and pressing the lower part of the rocker switch to turn the lights OFF. The lights should turn ON and OFF. If lights do not turn on, refer to the TROUBLESHOOTING section.
11.Upon successful testing, finish mounting the HA14WD unit to the wall box with the screws provided and install a decorator wall plate (not provided.)
Programming/Operation
Refer to your specific controller’s user manual for detailed instructions on adding modules (devices) to a
ing Installation/
of switch.
Top of Rocker switch:
A.Press and Release to turn light ON.
B.Press and Hold to DIM light up to specific level. (Release at desired level.)
C.Press and Release to INCLUDE/ EXCLUDE to Network or Scene.
D.Press and Release to ADD into Scene in ON position.
E.Press and Hold to ADD into Scene at specific DIM level. (Release at desired level.)
LED:
A.LED ON indicates switch is ON.
B.LED flashing indicates switch is communicating with
Bottom of Rocker switch:
A.Press and Release to turn light OFF.
B.Press and Hold to adjust DIM level to desired level. (Release at desired level.)
C.(Alternate) Press and Release to INCLUDE/EXCLUDE to Network or Scene.
D.Press and Release to ADD into Scene in OFF position.
E.Press and Hold to ADD into Scene at desired DIM level. (Release at desired level.)
Troubleshooting
1.Light does not turn ON:
•Lamp bulb is burned out - Replace.
•
•Wire connection is broken - Following all safety precautions, remove switch and check all connections.
•Circuit breaker or fuse has tripped - Reset/Replace.
2.Light flickers:
•Lamp bulb is not screwed in properly. - Check and tighten.
•Wire connection is intermittent - Following all safety precautions, remove switch and check connections.
3.
•Lamp bulb is burned out - Replace.
•Switch was programmed in the OFF position - Reprogram to ON position.
•
•Switch is not programmed to Network or Scene - Reprogram.
5
