Operating Instructions and Replacement Parts List | GPB400 |
|
|
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Engine Driven
Centrifugal Pump
Description
The WAYNE pumps are general use centrifugal water pumps. The pump is equipped with EPDM seals that are intended for water use only.
Safety Guidelines
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates an imminently hazardous
situation which, if NOT avoided, WILL result in death or serious injury.
Warning indicates a potentially hazardous
situation which, if NOT avoided, COULD result in death or serious injury.
Caution indicates a potentially minor or
moderate injury, if NOT avoided, MAY result in serious injury.
Notice indicates important
information, that if NOT followed, MAY cause damage to equipment.
General Safety
Information
CALIFORNIA PROPOSITION 65
This product may contain chemicals
known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
1.Know the pump application, limitations, and potential hazards. Read these rules and the instructions carefully. Failure to follow them could cause serious bodily injury and/or property damage.
NEVER run engine in
an enclosed area. Exhaust gases contain deadly poisonous carbon monoxide, which has no odor or taste.
Do NOT use to pump
flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do NOT use in flammable and/or explosive atmospheres. Pump SHOULD only be used with liquids compatible with pump component materials. Failure to follow this warning CAN result in personal injury and/or property damage.
2.Observe all safety precautions for the handling of the fuel.
Do NOT refuel a hot engine. Fuel spilled on a
hot engine could result in a fire or explosion. Do NOT refuel a running engine.
3.Pump should be located and should rest on a level solid foundation. Do NOT suspend pump by means of the discharge pipe.
Be sure pump is on secure footing so it
doesn’t fall over.
4.Do NOT use torches or apply excessive heat, fire or flames to this pump as an explosion may result.
5.Before working on the unit, insulate the wire from the spark plug, by disconnecting the spark plug wire from the spark plug.
Complete pump and piping system
MUST be protected against below freezing temperature. Failure to do so COULD cause serious damage and WILL void the warranty.
6.Do NOT run pump dry. Water is required to lubricate the shaft seal.
7.Pumping chemicals or corrosive liquids with this pump will shorten the life of the pump and may be hazardous to the operator and void the warranty.
8.Personal Safety:
a.Wear safety glasses at all times when working with pumps.
b.Keep work area clean, uncluttered and properly lighted; replace all unused tools and equipment.
c.Keep visitors at a safe distance from the work area.
d.Make workshop
9.This pump is designed for
Installation
This pump is designed to be
1.The pump should be placed as close as possible to the water being pumped. A pump with 20 foot suction lift will not remove water as quickly as a pump with 5 foot suction lift (Figure 1).
20 FT. SUCTION LIFT |
5 Ft. |
SUCTION |
LIFT |
Figure 1 |
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
© 2011, WAYNE/Scott Fetzer Company. | For parts, product & service information | |
| visit www.waynepumps.com |
|
