Step 21
Install swing table
You will need: swing table end bracket, two
Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 26 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 26 (b). The rod should swing freely inside the locking tab. Figure 26 (c).
(b) | (c) |
Support rod
(a)
Figure 26
Insert one end of the hinge rod into the hole in the frame. Figure 27 (a).
Insert the other end into the hole in the swing table end bracket. Figure 27 (b). Hold the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower tab of the bracket is hooked in the slot in the frame. Figure 27 (c).
To fully seat the bracket, you may have to tap it lightly with a hammer.
WARNING: If swing table end bracket is in any way cracked or damaged, do not use swing table. Call our Customer Service Center to order a new part.
WARNING: The load limit for the swing table is 30 pounds.
Hinge rod
(a)
(b)
View from rear
of barbecue
Slot in frame (view from below)
(c)
Figure 27
20
