Step 19
Install the lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place from the rear of the barbecue. Close and align the hinge at the rear. Insert hinge pins from the outside through the hinge. Insert hair pin cotters into the small holes in the hinge pins. Figure 24.
Hair pin cotter
Hinge pin
Figure 24
Step 20
Install tool holders, control panel and burner control knobs
You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.
Hook the tool holders over the frame rail. Figure 25.
Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 25 (a).
Push on the burner control knobs. Figure 25 (b).
Insert in
frame brace
Crossover |
|
Ignition Button | (a) |
|
Control panel
Phillips screws/
washers
(b)
Tool holders
Figure 25
19
