IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow these basic precautions:
Do not use an extension cord.
Unplug air conditioner before servicing.
Use two or more people to move and install air conditioner.
SAVE THESE INSTRUCTIONS
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
NOTE: Installation parts are supplied for
Location Requirements
Tools Needed
■
■Level
■Socket wrench and ⁷⁄₁₆" and ¹⁄₄" sockets
■Pencil
■Scissors
■Tape measure
■Drill and ³⁄₃₂" or smaller bit
■¹⁄₄" nut driver
■Utility knife
IMPORTANT: Observe all governing codes and ordinances.
Check the location where air conditioner will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation.
The location should provide:
■ | Grounded electrical outlet within 4 ft (122 cm) of where the |
| power cord exits the air conditioner. |
| NOTE: Do not use an extension cord. |
■ | Free movement of air in room to be cooled. |
Through-the-wall installation:
In addition to the tools listed above, the following tools are needed for
■ | Saw | ■ | 1" (2.5 cm) or thicker |
■ | Wood preservative |
| lumber |
| 7 - #10 x 1" wood screws | ||
■ | Caulk | ■ | |
|
|
■ | A large enough opening for the air conditioner. |
■ | Adequate wall support for weight of air conditioner. Air |
| conditioner weighs between 145 and 200 lbs (65 to 96 kg). |
NOTES: Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.
Parts supplied (on some models)
Check that all parts are included in parts package.
ABC DA
E F G
H
I | J | A. Cabinet louvers |
|
K
L
M N O P
A.
B.Filler board
C.Vertical supports (2)
D.Foam blocks (4)
E.Nuts (6)
F. Flat washers (6)
G. Lock washers (6) H. Angle supports (2)
I. 2¹⁄₂" (6.4 cm) seal strip
J. Foam seals for air conditioner (3)
K. Foam window sash seal
L. Window rail seal
M. #8 x ¹⁄₂"
N. #10 x ³⁄₄"
O. #8 - 18 x ³⁄₈" round- head screws (2)
P.³⁄₄"
3