Step 10
Add fuel scale
You will need: fuel scale, two
Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame.
Add washers, then wing nuts and tighten. Figure 11.
Figure 11
| E |
| E |
| F |
| F |
View from front left | View from front right |
Step 11
Install igniter
Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 12 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure (c). Tighten the igniter lock nut. Figure 12.
Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
Frame brace
(a)
(b)
Keyhole 
in frame
brace
Small part of | Igniter | |
keyhole in | lock nut | |
frame brace | ||
| ||
| (c) |
Figure 12
Frame brace
Step 12
Check that all burner valves are off
You will need: one burner control knob.
(Valves are shipped in the OFF position, but you should check to be sure.) Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off, proceed to the next step. Figure 13.
Figure 13
14
