Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 29.
Notch to the front
Slide bar
View from front of barbecue
Step 22
Complete accessory installation
You will need: work table, two accessory trays,
Insert one end of the Weber
Set the work table onto the left side rails. Figure 31 (b).
Set the accessory trays between the two frame connectors. Figure 31 (c).
Set the warming rack into the slots at the rear of the cooking box. Figure 31 (d).
Insert the thermometer into its holder. Figure 31 (e).
Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 31 (f).
Figure 29
To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 30.
(a)
(d)
(e)
(b)
Support rod |
|
| (f) |
View from rear | (c) |
of barbecue |
|
Slide
Figure 31
mCAUTION: To keep the barbecue stationary, the tabs on the locking casters should be in the down position.
Unlocked position | Locked position |
Figure 30
21
