Weber 386002 Do not use an open flame to check for, Gas leaks. Be sure there are no sparks

Attach Propane Cylinder

Use propane cylinders with a capacity of 14.1 oz or less. Use propane cylinders that are approximately 3" inches in diameter and 11" inches in length. The propane cylinder must fit through the cylinder support ring (1).

CAUTION: Use cylinders that are marked “Propane fuel” only.

Note: Your Weber® gas grill is equipped with a cylinder supply system designed for vapor withdrawal.

Slide propane cylinder through support ring (1). While holding carrying handle closest to propane cylinder with one hand, push propane cylinder into regulator and turn clockwise until tight.

WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.

Check for gas leaks:

1)Regulator to propane cylinder connection.

WARNING: If there is a leak at connection (1), remove propane cylinder. Do not operate grill. Use a different propane cylinder and recheck for leaks with soap and water solution. If a leak persists after retightening the propane cylinder, turn OFF the gas. DO NOT OPERATE

THE GRILL.

Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

2) Valve to-regulator connections.

WARNING: If there is a leak at connection

(2)turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

1)

	DANGER
	Do not use an open flame to check for
	gas leaks. Be sure there are no sparks
	or open flames in the area while you
	check for leaks. Sparks or flames will
	result in a fire or explosion which can
	cause serious bodily injury or death, and
	damage to property.
	DANGER
	Do not store a spare LP-gas cylinder under or near this
	appliance. Never fill the cylinder beyond 80 percent
	full. If the instructions are not followed exactly, a fire
1 ).	causing death or serious injury may occur.

1).

2).

6).

5).

Lighting

Summary lighting instructions are on the fold out work surface.

1)Open the lid.

2)Unfold the work surfaces.

3)Make sure the control knob is turned OFF. (Push control knob in and turn clockwise to

2).

ensure that it is in the OFF

position.) WARNING: Do not lean over the open grill. Keep your face and body at least one foot away from the matchlight hole when lighting the grill.

4)Push burner control knob down and turn to START/HI.

5)Push the red ignition button several times, so it clicks each time.

6)Check that the burner is lit by looking down through the cooking grate. You should see a flame. WARNING: If the burner does not light, turn the burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

3). OFF 4).

START/

HI

To Extinguish

			Push in and turn burner control
	DANGER		knob clockwise to the OFF
			position.	CAUTION do not
Failure to open the lid while igniting the grill’s burner, or not waiting 5 minutes to allow			fold in tables until grill is cold.
the gas to clear if the grill does not light, may result in an explosive flame-up which
can cause serious bodily injury or death.
Manual Lighting	6) Push burner control knob down
1) Open the lid.	and turn to START/HI.
2) Unfold the work surfaces.	7) Check that the burner is lit by
3) Make sure the burner control knob	looking down through the cooking
	grate. You should see a flame.
is turned OFF.				5).
	WARNING: If the burner does
WARNING: Do not lean over		START/
	not light, turn the burner control	HI
the open grill. Keep your face
	knob to OFF and wait 5 minutes
and body at least one foot away
	to let the gas clear before you	2).
from the matchlight hole when				6).
	try again or try to light with a
lighting the grill.		4).
	match.
4) Turn the cylinder on by turning the		5).		1).
cylinder valve counterclockwise.
5) Strike a match and put the flame		OFF
into the matchlight hole under
the igniter.		3).		2).

pg6