Weber 42092 manual Check for gas leaks

Gas Instructions
Check for gas leaks	WARNING: If there is a leak at connections (3,4,5,6,
	or 7), turn OFF the gas. DO NOT OPERATE THE GRILL.
DANGER	Contact the Customer Service Representative in your
Do not use an open flame to check for gas	region using the contact information sheet provided
	with your manual.
leaks. Be sure there are no sparks or open
	When leak checks are complete, turn gas supply OFF at
flames in the area while you check for leaks.
	the source and rinse connections with water.
Sparks or open flames will result in a fire or
explosion, which can cause serious bodily
injury or death and damage to property.	(2)	(1)
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - All factory-made connections have been
thoroughly checked for gas leaks. The burners have been
flame-tested. As a safety precaution however, you should
recheck all fittings for leaks before using your Weber Gas
Barbecue. Shipping and handling may loosen or damage
a gas fitting.
WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or		(3)
brush to apply it.
Note - Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should
be rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning
the cylinder valve hand-wheel counterclockwise.		(4)
WARNING: Do not ignite burners when leak
checking.
Check for leaks by wetting the connections with the soap	(7)
and water solution and watching for bubbles. If bubbles
form or if a bubble grows, there is a leak.
Check:
1) Hose connection.
2) Gas line to manifold connections.	(6)	(5)
WARNING: If there is a leak at connection (1, or 2),
retighten the fitting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after re-tightening the fitting, turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact
the Customer Service Representative in your region
using the contact information sheet provided with
your manual.

3)Side burner hose to manifold connection

4)Side burner hose to side burner connection

5)Regulator to cylinder connection.

6)Hose to regulator connection.

7)Valves to manifold connections.

C-4