GAS INSTRUCTIONS
If you have questions about spare LP cylinders contact
Customer Service at
•All LP tank supply systems must include a collar to protect the cylinder valve.
•The LP cylinder must be a
•The cylinder should be constructed and marked in accordance with the Specifi cations for LP - Gas Cylinders of the U.S. Department of Transportation (D.O.T.) or the National Standard of Canada,
(1)
DOT 4BA240
00/02
(2)
TANK ENCLOSURE TROUBLESHOOTING
PROBLEM | CHECK | CURE |
|
|
|
Burner does not light. | Is gas supply off? | Turn supply on. |
|
|
|
Flame is low in HIGH position. | Is fuel hose bent or kinked? | Straighten fuel hose. |
|
|
|
Burners do not light | The excess fl ow safety device, which is part of | To reset the excess flow safety device turn all |
small flickering flame in the HIGH position | the barbecue to cylinder connection, may have | burner control knobs and the cylinder valve |
activated. | OFF. Disconnect the regulator from the cylinder. | |
barbecue temperature only reaches 250˚ to |
| Turn burner control knobs to HIGH. Wait at |
300˚F in the HIGH position |
| least 1 minute. Turn burner control knobs OFF. |
|
| Reconnect the regulator to the cylinder. Turn |
|
| cylinder valve on slowly. Refer to “Lighting |
|
| Instructions”. |
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
www.weber.com®
©2005- The following trademarks are registered in the name of