Weber 43176 Gas Instructions, Built-Incutout Dimensions, Tank Cabinet Cutout Dimensions, S-440

4 GAS INSTRUCTIONS

LOCATING YOUR LP TANK CABINET

When determining a suitable location for your LP Tank Cabinet installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping any

gas supply lines as short as possible. Never locate the Summit® LP Tank Cabinet in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP Tank Cabinet and structure so there is enough room to safely evacuate the area in case of a fire.

CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES

WARNING: Clearance from the outside walls of the sides and back of the LP Tank Cabinet must be a minimum of 24 inches (610 mm) from any surface. Refer to “Typical Gas Supply Installation” before starting installation.

WARNING: The structure, “island” counter tops and adjacent work areas for the LP Tank Cabinet installation must be built from noncombustible materials only.

NOTE: If you have questions on what materials are considered noncombustible, contact your local building supplier or fire department.

BUILT-IN STRUCTURE CUTOUT DIMENSIONS

All dimensions are to finished surfaces.

WARNING: All counter top finished surfaces must be constructed of a noncombustible material.

			c
		1
b	1			1	b
			a

BUILT-IN CUTOUT DIMENSIONS

S-440, S-640

1 24” (610 mm) minimum*

aLP Tank Cabinet

bAny Surface

cNon-Combustable Surface

A

B

C

TANK CABINET CUTOUT DIMENSIONS

S-440	TOLERANCES
20 3/4˝ (527.05 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
27 1/2˝ (698.5 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
14˝ (355.6 mm)	+ 1/4˝	- 1/4˝ (6.35mm )

WWW.WEBER.COM®