Weber 43176 manual Assembly

ASSEMBLY

BUILT-IN GAS LINE LOCATIONS

GENERAL CONSTRUCTION DETAILS

•Summit® Built-In unit and all other accessory units should be on site before construction begins.

•All dimensions have a tolerance of plus or minus (+/-) 1/4 inch (6.4mm).

1

1

		BUILT-IN CUTOUT DIMENSIONS
		S-440, S-640
	1	24” (610 mm) minimum*
DIMENSIONS	5
		20 3/4” (527.1 mm)
	2	5” (127 mm)
	3	2 1/2” (63.5 mm)
	4	14” (355.6 mm)
	6
		27 1/2” (698.5 mm)

aGas Inlet

* Clearance from any surface or structure is at least 24” (610mm) from the back and sides of the grill or side burner.

BUILT-IN GAS LINE LOCATIONS

Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure.

B

C

		5
3		2
		a
		1
		2
a
4
	5	6
		1
2
		3
		A
		A
		B
		C
		C

LP TANK CABINET GAS LINE DIMENSIONS

Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure.

1

2

3

A

B

C

D

GAS LINE DIMENSIONS

TANK CABINET	TOLERANCES
5” (127 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
2 1/2” (63.5 mm)	+ 1/4˝	- 1/4˝ (6.35mm)
2 3/4” (69.85 mm)	+ 1/4˝	- 1/4˝ (6.35mm)

Front View

Plan View

Side View

Front of LP Tank Cabinate Structure

WWW.WEBER.COM®