Weber 54329 instruction manual GAS Instructions, Attach the Propane Cylinder, Check for GAS Leaks

GAS INSTRUCTIONS

ATTACH THE PROPANE CYLINDER

Use disposable propane cylinders with a capacity of either 14..1 oz.. or 16..4 oz.. equipped with a CGA #600 connection..

mCAUTION: Use cylinders that are marked “Propane fuel”

only.

Note: Your Weber® gas grill is equipped with a cylinder supply system designed for vapor withdrawal.

Make sure the Burner is in the off position..

While holding carrying handle closest to propane cylinder with one hand, push propane cylinder into regulator and turn clockwise until tight..

m WARNING: Do not use a wrench to tighten the connection.

Using a wrench could damage the regulator coupling and could cause a leak.

m DANGER

Do not store a spare LP-gas cylinder under or near this appliance. If the instructions are not followed exactly, a fire causing death or serious injury may occur. ◆

CHECK FOR GAS LEAKS

m DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

Note: All factory-made connections have been thoroughly checked for gas leaks.The
burners have been flame tested.As a safety precaution however, you should recheck
all fittings for leaks before using your Weber® gas grill. Shipping and handling may have
loosened or damaged a gas fitting.	1
m WARNING: Perform these leak checks even if your grill was
dealer or store assembled.

You will need a soap and water solution and a rag or brush to apply it.. To perform leak checks make sure the Burner is in the off position..

mWARNING: Do not ignite burner while leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles.. If bubbles form, or if a bubble grows, there is a leak..

Check:

A) Regulator-to-propane cylinder connection (1)..

m WARNING: If there is a leak at connection (1), remove	2
propane cylinder. Do not operate grill. Use a different
propane cylinder and recheck for leaks with soap and water
solution. If a leak persists after retightening the propane
cylinder, remove propane cylinder. DO NOT OPERATE THE
GRILL. Contact the Customer Service Representative in
your area using the contact information on our web site.
Log onto www.weber.com®.

B) Valve-to-regulator connections (2)..

mWARNING: If there is a leak at connection (2), remove propane cylinder. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site.

Log onto www.weber.com®.

C) When leak checks are complete, rinse connections with water..

Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. ◆

10