Weber 55249 Gas Instructions, Check for gas leaks, Danger, injury or death and damage to property

Gas Instructions

Remove control panel and burner control knobs	Check for gas leaks
You will need: Phillips screwdriver.	DANGER
1) Remove control knobs.
2) Unhook side burner from Cookbox Frame.	Do not use an open flame to check for gas
3) Remove screws with a Phillips screwdriver	leaks. Be sure there are no sparks or open
4) Pull up igniter button until it sticks in the up position and	flames in the area while you check for leaks.
remove control panel from grill.	Sparks or open flames will result in a fire or
(1)	explosion, which can cause serious bodily
	injury or death and damage to property.
	WARNING: You should check for gas leaks every
	time you disconnect and reconnect a gas fitting.
	Note - All factory-made connections have been thoroughly
(2)	checked for gas leaks. The burners have been flame-tested.
	As a safety precaution however, you should recheck all
	fittings for leaks before using your Weber Gas Barbecue.
	Shipping and handling may loosen or damage a gas fitting.
	WARNING: Perform these leak checks even if your
	barbecue was dealer or store assembled.
	You will need: a soap and water solution, and a rag or
	brush to apply it.
(4)	Note - Since some leak test solutions, including soap and
	water, may be slightly corrosive, all connections should be
(3)	rinsed with water after checking for leaks.
	Make sure side burner is OFF.
	To perform leak checks: open cylinder valve by turning the
	cylinder valve hand-wheel counterclockwise.
	WARNING: Do not ignite burners when leak
	checking.
	Check for leaks by wetting the connections with the soap
	and water solution and watching for bubbles. If bubbles
	form or if a bubble grows, there is a leak.

5) Replace control panel when Leak Check is completed.

C-3