Weber 55249 Operating Instructions, Lighting, To Extinguish, death, Crossover Ignition System

		Operating Instructions
Lighting			DANGER:
Summary lighting instructions are on the control panel.
			When the “excess gas flow control” feature is
		DANGER	activated, a small amount of gas I still flowing to the
			burners. After turning OFF the cylinder knobs, wait at
Failure to open the lid while igniting the
			least 5 minutes for the gas to clear before attempting
barbecue’s burners, or not waiting 5 minutes			to light the barbecue. Failure to do so may result in an
to allow the gas to clear if the barbecue does			explosive flame-up, which can cause serious bodily
not light, may result in an explosive flame-up			injury or death.
which can cause serious bodily injury or			3) Turn the cylinder on by turning the cylinder valve
death.			counterclockwise.
			WARNING: Do not lean over the open barbecue.
Crossover® Ignition System			Keep your face and body at least one foot away
Note - The Crossover® ignition system ignites the Front			from the matchlight hole when lighting the
burner with a spark from the igniter electrode inside the			barbecue.
			4) Push Front burner control knob down and turn to
Gas Catcher™ ignition chamber. You generate the energy
			START/HI.
for the spark by pushing the Crossover® ignition button
until it clicks.			5) Push the Crossover® ignition button several times, so it
			clicks each time.
WARNING: Check hose before each use of barbe-
			6) Check that the burner is lit by looking through the
cue for nicks, cracking, abrasions or cuts. If the
			matchlight hole on the front of the cooking box. You
hose is found to be damaged in any way, do not use
			should see a flame.
the barbecue. Replace using only Weber® autho-
rized replacement hose. Contact the Customer			WARNING: If the burner does not light, turn the
			Front burner control knob to OFF and wait 5
Service Representative in your region using the
			minutes to let the gas clear before you try again or
contact information sheet provided with your
			try to light with a match.
manual.
			7) After the FRONT burner is lit you can turn on the other
1			burner or burners.
			Note - Always light the FRONT burner first. The
			other burner or burners ignite from the FRONT
			burner.
		2	To Extinguish
		7
			Push down and turn each burner control knob clock-
			wise to the OFF position. Turn gas supply OFF at the
		3	source.
6	4	5

*The grill illustrated may have slight differences than the model purchased.

1)Open the lid.

2)Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that it is in the OFF position.)

WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane cylinder tank valve. If they are not in the OFF position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn OFF the LP cylinder valve and burner control knobs. Then start over.

D202_LP.c

D-1