| SIDE BURNER TROUBLESHOOTING | 19 | |
PROBLEM | CHECK | CURE |
|
|
|
|
|
Side Burner does not light. | Is gas supply off? | Turn supply on. |
|
| The excess flow safety device, which is part | To reset the excess flow safety device turn all burner control knobs and the cylinder | |
| of the barbecue to cylinder connection, may | valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to | |
| have activated. | START/HI. Wait at least 1 minute. Turn burner control knobs to “OFF”. Reconnect | |
|
| the regulator to the cylinder. Turn cylinder valve on slowly. Refer to “Lighting |
|
|
| Instructions”. |
|
|
|
|
|
Flame is low in “HI” position. | Is the fuel hose bent or kinked? | Straighten hose. |
|
|
|
|
|
Push button ignition does not work. | Does burner light with a match? | If match lights burner, check igniter (see Sideburner Maintenance). |
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
IGNITER
If the Ignition system fails to ignite the side burner, light the burner with a match.
• Check that both ignition wires are attached properly.
• You should hear the igniter sparking.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com®.
GENERAL MAINTENANCE
SIDE BURNER MAINTENANCE
WARNING: All gas controls and supply valves should be in the “OFF” position.
Make sure ignition wires(1) are connected between the igniter and electrodes.
Make sure grounding wire(2) is connected between the igniter and grounding clips on the burner cups.
Spark should be a white/blue color, not yellow.
1)Igniter Wires
2)Ground wire
3)Burner
2 | 1 | 3 |
|
|
1
WWW.WEBER.COM®
