OPERATING / MAINTENANCE | 9 |
|
|
MANUALLY LIGHTING THE SIDE BURNER
DANGER
Failure to open the lid while igniting the side burner, or not waiting 5 minutes to allow the gas to clear if the side burner does not light, may result in an explosive
1)Open the side burner lid.
2)Check that the side burner valve is turned OFF. (Push the knob down and turn clockwise to ensure that it is in the off position.).
3)Turn the gas supply valve on.
4)Put match in a match holder and strike match.
5)Push down and turn the side burner control valve to START/HI.
6)Hold match holder and lit match by right side of side burner.
IGNITER
If the Ignition system fails to ignite the side burner, light the burner with a match.
•Check that both ignition wires(1,2) are attached properly.
•You should hear the igniter sparking.
If the ignition system still fails to light, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
REPLACE IGNITER BATTERIES
Parts required: 1 AA alkaline battery per igniter.
Unscrew igniter button from front of control panel. Remove igniter button and contact spring. Remove old battery and replace with a new AA
alkaline battery. Positive end (1) of battery faces inward as shown in illustration. Replace spring contact (2) and screw igniter button (3) back onto battery compartment.
7)Push igniter button and hold until burner ignites. You will hear the igniter sparking.
CAUTION: Side burner flame may be difficult to see on a bright sunny day.
WARNING: If the side burner does not light:
1)Turn OFF the side burner control valve.
2)Wait 5 minutes to let the gas clear before you try again or try to light with a match.
TO EXTINGUISH
Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source.
WWW.WEBER.COM®
