Step 8
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner valve. Figure 9. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace.
Frame brace | Manifold bracket |
|
Figure 9
Step 9
Install frame connector
You will need: frame connector, two
Slip a washer on a bolt and insert through the hole in the cross brace and into the end of the frame connector. Insert the other bolt and washer into the other end through the cross brace and into the frame connector. Hold the frame connector square and tighten the bolts. Figure 10.
Figure 10
Step 10
Install gas supply
General Specifications for Piping
Note - Contact your local municipality for building codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must conform to the latest edition of ANSI Z223.1. WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL.
Some of the following are general requirements taken from ANSI Z223.1, for gas supply installations. Refer to ANSI Z223.1 latest edition for complete specifications.
■This barbecue is designed to operate at 7 inches of water column pressure (.2526 psi).
■A manual
■An additional manual
installed in the branch fuel line in an accessible location near the supply line.
■The quick disconnect connects to a 3/8 inch NPT
thread from the gas source. The quick disconnect fitting is a
■The quick disconnect fitting can be installed
horizontally, or pointing downward. Installing the fitting with the open end pointing upward can result in collecting water and debris.
■The dust covers (supplied plastic plugs) help keep the
open ends of the quick disconnect fitting clean while disconnected.
mWARNING: Do not route the 12’ hose under a deck.
The hose must be visible.
13
