Step 4
Continue frame assembly
You will need: frame assembly, front panel, four 1/2 inch bolts, four nylon washers, 7/16 inch wrench.
Place front panel along inside edge of frame assembly with Weber logo on the side closest to the wheel frame and facing out. Slip washers on bolts, insert bolts through the front panel and screw into the frame assembly. Figure 4.
Add the remaining bolts and washers and tighten.
Weber nameplate facing out
Figure 4
Step 5
Complete frame assembly
You will need: two bottom connectors, four 1 3/4 inch bolts, four nylon washers, 7/16 inch wrench.
Turn over partial frame assembly.
Place washer on bolt, insert through frame, and screw into bottom connector. Do not fully tighten bolts until both bottom connectors are in place. Place washer on second bolt and insert through frame into opposite end of bottom connector. Figure 5.
Hold the other bottom connector between wheel and leg frame. Add washers to bolts. Insert bolts through frame and screw into bottom connector. Figure 5. Tighten all four bolts.
Bottom connector
Figure 5
12
