Gas Instructions
We utilize various LP tank manufacturers. Some of the | Note: This connection tightens clockwise and will not allow | |||||
tanks have differing top collar assembles. (The top collar | gas to flow unless the connection is tight. The connection | |||||
is the metal protective ring around the valve.) One series | requires tightening by hand only. | |||||
of tanks mount with the valve facing front. The other tanks | WARNING: Do not use a wrench to tighten the | |||||
mount with the valve facing away from the fuel scale. | connection. Using a wrench could damage the | |||||
These types of tanks are illustrated below. | regulator coupling and could cause a leak. | |||||
You will need: LP cylinder, a soap and water solution and a | 5) Mix soap and water. | |||||
rag or brush to apply it. | 6) Turn on the cylinder valve. | |||||
1) Turn the LP cylinder so the opening of the valve is |
|
|
|
|
|
|
either to the front, side or rear of the Weber® gas |
|
|
|
|
|
|
|
|
|
|
|
| |
barbecue. Lift and hook the cylinder onto the fuel |
|
|
|
|
|
|
gauge. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| 7) Check for leaks by wetting the fitting with the soap and | |
| water solution and watching for bubbles. If bubbles | |
| form, or if a bubble grows, there is a leak. | |
| If there is a leak, turn off the gas and tighten the fitting. Turn | |
| the gas back on and recheck with the soap and water | |
2) Loosen the cylinder lock wing nut. Swing the cylinder | solution. | |
If leak does not stop, Contact the Customer Service | ||
lock down. Tighten the wing nut. | ||
Representative in your region using the contact information | ||
| ||
| sheet provided with your manual. Do not use the barbecue. | |
| 8) When leak checking is complete, turn gas supply OFF | |
| at the source and rinse connections with water. |
To Connect the hose to the cylinder:
3)Remove the plastic dust cover from the valve.
4)Screw the regulator coupling onto the tank valve, clockwise, or to the right.
