Operating Instructions

Lighting

 

1) Open the lid.

Summary lighting instructions are on the control panel.

 

2) Make sure all burner control knobs are turned OFF.

 

(Push control knob down and turn clockwise to ensure

 

 

DANGER

 

that it is in the OFF position.)

Failure to open the lid while igniting the barbecue’s

 

WARNING: The burner control knobs must be in the

burners, or not waiting 5 minutes to allow the gas to

OFF position before turning on the liquid propane

clear if the barbecue does not light, may result in an

cylinder tank valve. If they are not in the OFF

explosive flame-up which can cause serious bodily

 

position, when you turn on the LP cylinder valve,

injury or death.

 

the “excess gas flow control” feature will activate,

 

 

limiting the flow of gas from the LP cylinder. If this

Crossover® Ignition System

 

should occur, turn OFF the LP cylinder valve and

Note - The Crossover® ignition system ignites the set of left

burner control knobs. Then start over.

burners with a spark from the igniter electrode inside the

DANGER:

Gas Catcher™ ignition chamber. You generate the energy

When the “excess gas flow control” feature is

for the spark by pushing the electronic ignition button.

 

 

activated, a small amount of gas is still flowing to the

WARNING: Check hose before each use of

 

 

burners. After turning OFF the cylinder knobs, wait at

barbecue for nicks, cracking, abrasions or cuts. If

least 5 minutes for the gas to clear before attempting

the hose is found to be damaged in any way, do not

to light the barbecue. Failure to do so may result in an

use the barbecue. Replace using only Weber®

 

authorized replacement hose. Contact the

 

explosive flame-up, which can cause serious bodily

 

injury or death.

Customer Service Representative in your region

 

 

 

using the contact information sheet provided with

3) Turn the cylinder on by turning the cylinder valve

your manual.

 

 

counterclockwise.

 

 

 

 

WARNING: Do not lean over the open barbecue.

 

 

4) Select the burner set you want to operate.

 

 

5) Push LEFT burner control knob down and turn to

1

 

START/HI in selected burner set.

 

6) Push igniter button and hold until burner ignites. You

 

 

 

 

will hear the igniter sparking.

 

 

7) Check that the burner is lit by looking through the

4,5,8

 

cooking grates. You should see a flame.

 

 

WARNING: If the burner does not light, turn the

 

 

LEFT burner control knob to OFF and wait 5

 

 

minutes to let the gas clear before you try again or

7

 

try to light with a match.

 

8) After the LEFT burner is lit you can turn on the RIGHT

 

 

burner adjacent to it. The RIGHT burner lights from the

 

 

LEFT burner.

2

3

 

6

 

To Extinguish

 

 

2

 

Push down and turn each burner control knob

 

clockwise to the OFF position. Turn gas supply OFF at

 

 

the source.

*The grill illustrated may have slight differences than the model purchased.

D-3

Page 36
Image 36
Weber LP GAS GRILL manual Lighting, To Extinguish