Weber S-640-NG, 43157 manual Cooking, Lighting the Rotisserie Burner, Lighting Rotisserie Burner

16 OPERATING INSTRUCTIONS

WARNING: Setup up the rotisserie with food before lighting rotisserie burner.

OPERATING

1)Remove rotisserie shaft from grill. Remove one spit fork.

2)Push the rotisserie shaft through the center of the food.

3)Slide the spit fork onto the shaft. Insert the tines of both spit forks into the food. The food should be centered on the shaft. Tighten the spit fork screws

4)Place the motor in the bracket, slide to lock.

5)Insert the pointed end of the rotisserie shaft into the motor. Place the handle end of the rotisserie onto the support rollers.

6)The rotisserie shaft should rotate so that the heavy side of the meat or poultry rotates down to the bottom. Large cuts may require the removal of the cooking grates and warming rack to allow full rotation of the shaft. Remount the food if necessary for better balance.

7)Turn the motor on.

COOKING

•Meats (except poultry and ground meat) should be brought to room temperature before cooking. (20 to 30 minutes should be adequate for most foods. If frozen defrost completely before cooking.)

•Tie meat or poultry with a string, if necessary, to make the shape as uniform as possible before putting it on the spit.

•Remove cooking grates and warming rack to allow food to turn freely.

•Follow lighting instructions for rotisserie burner on next page.

•Set rotisserie burner on medium-high based on outside air temperatures.

•Place food within area of burner.

•If you wish to save drippings for gravy, place a drip pan directly under the food on top of the Flavorizer® bars.

•Food preparation steps are the same for rotisserie cooking as for regular cooking.

•All cooking is done with the lid closed.

•If foods are too heavy or are irregular shapes, they may not rotate well and should be cooked by the Indirect Method without using the rotisserie.

•Smoker can be used in conjunction with rotisserie for more smoke flavor.

Note: When using the rotisserie burner, grill thermometer will not reflect the temperature inside the cooking box.

LIGHTING THE ROTISSERIE BURNER

ROTISSERIE BURNER SNAP IGNITION

Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”. This will ignite each individual burner.

ATTENTION: READ BEFORE

LIGHTING ROTISSERIE BURNER

After a period of non-use, before lighting the Rotisserie Burner, a few seconds must pass for the gas supply line to fill.

When using the snap igniter you will see a flash of flames moving from left to right across the Rotisserie Burner surface, the Rotisserie Burner is not lit until the entire ceramic surface is aflame.

At this point, start a count of 20 seconds before releasing the Rotisserie Burner control knob.

1

2

5

3

*The grill illustrated may have

6

The Rotisserie Burner surface will glow red once the burner is fully ignited.

DANGER

Failure to open the lid while igniting the grill, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.

CAUTION: The Rotisserie Burner flame may be difficult to see on a bright sunny day.

WARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only a Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site.

Log onto www.weber.com®.

1)Open the lid.

2)Remove the warming rack and the cooking grates from the cookbox.

3)Make sure all burner control knobs are turned to “OFF”. (Push control knob in and turn clockwise to ensure that it is in the “OFF” position.)

4)Turn on the gas at source.

WARNING: Do not lean over the open grill.

5)Push the control knob in and turn to “START/HI”. This action will spark the igniter and light the Rotisserie Burner. Continue to use the snap igniter until the Rotisserie Burner has ignited. Release the control knob.

slight differences than the4 model purchased.

6)Check that the burner is lit by looking for the rotisserie burner to glow red.

WARNING: If the rotisserie burner does not light, turn the burner control knob to “OFF” and wait 5 minutes to let the gas clear before you try again or try to light with a match.

Note: When using the rotisserie with the lid closed, only light two of the main burners on each side of the food (See Grilling Methods-Indirect Cooking). Check your food periodically to prevent over cooking on the outside. Turn off the rotisserie burner once the food has browned to the desired color. Finish cooking on Indirect heat.

TO EXTINGUISH

Push in and turn each burner control knob clockwise to “OFF” position. Turn gas supply off at the source.

WWW.WEBER.COM®