![](/images/new-backgrounds/1256382/25638257x1.webp)
Annual Maintenance
After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety.
WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.
■Inspect the burners for correct flame pattern. Clean if necessary, following the procedures outlined in the “General Maintenance” section of this manual.
■Check all gas fittings for leaks.
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion, which can cause serious bodily injury or death, and damage to property.
WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
Note - All
WARNING: Perform these leak checks even if your barbecue was dealer- or
To perform leak checks: Make sure all Burners are in the off position. Turn on gas supply.
WARNING: Do not ignite burners while leak checking.
Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
Check:
1)
WARNING: If there is a leak at the
If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE.
Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.
2)
3)The
WARNING: If there is a leak at connections (2) or
(3), turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
(1)
(2)
(3)
*The grill illustrated may have slight differences than the model purchased.
Inspection and cleaning of the Spider/Insect screens
To inspect the spider/insect screens, remove the control panel. If there is dust or dirt on the screens, remove the burners for cleaning the screens. Refer to Maintenance, Replacing Main Burners. Brush the spider/inspect screens, lightly, with a soft bristle brush (i.e. an old toothbrush).
Caution: Do not clean the spider/insect screens with hard or sharp tools. Do not dislodge the spider/insect screens or enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube. Once the spider/insect screens and burners are clean replace the burners.
If the spider/insect screen becomes damaged or cannot be cleaned, call