Weber Natural Gas Barbecues manual Built-In Side Burner, For Summit Natural Gas Cooking Modules

GENERAL INFORMATION

BUILT-IN SIDE BURNER

For Summit Natural

Gas Cooking Modules

THIS ACCESSORY MAY BE PURCHASED SEPERATELY.

THIS GAS APPLIANCE IS DESIGNED

FOR OUTDOOR USE ONLY.

BUILT-IN CONSTRUCTION GENERAL INFORMATION

WARNING

A Weber-Stephen Products Co. insulated sleeve must be used for any built-in installation.

LOCATING YOUR SIDE BURNER

When determining a suitable location for your side burner installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the Weber Gas Side Burner in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the side burner and structure so there is enough room to safely evacuate the area in case of a fire.

CLEARANCE FROM NON-COMBUSTIBLE SURFACES OR STRUCTURES

Warning: Clearance from the outside walls of the sides and back of the sleeve must be a minimum of 6 inches from a non-combustible surface. Measure from the outside wall of the sleeve to the non-combustible surface. Figure 1. Refer to “Install Gas Supply” on page 2 before starting installation.

CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES

Warning: Clearance from the outside walls of the sides and back of the sleeve must be a minimum of 24 inches from a combustible surface. Measure from the outside wall of the sleeve to the combustible surface. Figure 2. Refer to “Install Gas Supply” on page 2 before starting installation.

NON- COMBUSTIBLE SURFACE

6 inches
6 inches	6 inches
Insulated sleeve	Countertop

Figure 1

WARNING: All countertop finished surfaces must be constructed of a noncombustible material.

COMBUSTIBLE SURFACE

24 inches
24 inches	24 inches
Insulated sleeve	Countertop

Figure 2

5WARNING: All countertop finished surfaces must be constructed of a noncombustible material.