Weber 38008, summit gas grill lp gas grill

GAS INSTRUCTIONS

Note: This connection tightens clockwise and will not allow gas to ﬂ ow unless

the connection is tight. The connection requires tightening by hand only.

 WARNING: Do not use a wrench to tighten the

connection. Using a wrench could damage the

regulator coupling and could cause a leak.

5) Mix soap and water.

6) Turn on the cylinder valve.

7) Check for leaks by wetting the ﬁ tting with the soap and water solution

and watching for bubbles. If bubbles form, or if a bubble grows, there is

a leak.

If there is a leak, turn off the gas and tighten the ﬁ tting. Turn the gas back on

and recheck with the soap and water solution.

If leak does not stop, Contact the Customer Service at 1-800-446-1071

or locate the Customer Service Representative in your area using the

contact information on our web site. Log onto www.weber.com®. Do not

use the barbecue.

8) When leak checking is complete, turn gas supply OFF at the source

and rinse connections with water.

CHECK FOR GAS LEAKS

WARNING : The gas connections of your Summit®

gas grill have been factory tested. We do however

recommend that you leak check all gas connections

before operating your Summit® gas grill.

REMOVE CONTROL PANEL

Part required: Phillips Screwdriver.

Remove the burner control knobs (1). The screws (2) need to be removed

from the control panel (3) before the control panel is removed from the grill.

(1)

(2)

(3)