SERVICE AND ADJUSTMENTS
ENGINE
PULLEY
CLUTCHING
IDLER
STATIONARY
IDLER
CENTER SPAN KEEPER
TRANSAXLE
PULLEY
00811 |
TO ADJUST STEERING WHEEL ALIGN- MENT
If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel
TO REMOVE WHEEL FOR REPAIRS (See Fig. 22)
• | Block up axle securely. |
• | Remove axle cover, retaining ring and washers to allow |
| wheel removal (rear wheel contains a square key - Do |
| not lose). |
FIG. 20
TRANSAXLE GEAR SHIFT LEVER NEUTRAL- ADJUSTMENT (See Fig. 21)
The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:
•Make sure transaxle is in neutral (N).
NOTE: When the tractor rear wheels move freely, the transaxle is in neutral.
•Loosen adjustment bolt in front of the right rear wheel.
•Position the gear shift lever in the neutral (N) posi- tion.
•Tighten adjustment bolt securely.
NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.
NEUTRAL
LOCK GATE
GEARSHIFT LEVER
| ADJUSTMENT |
02239 | BOLT |
FIG. 21
• Repair tire and reassemble. |
• On rear wheels only: align grooves in rear wheel hub |
and axle. Insert square key. |
• Replace washers and snap retaining ring securely in |
axle groove. |
• Replace axle cover. |
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
WASHERS
RETAINING
RING
AXLE
COVER
00663
SQUARE KEY (REAR
WHEEL ONLY)
FIG. 22
21
