Weed Eater 530088132 Check For Loose Fasteners And Parts, Check For Damaged Or Worn Parts

WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments.

CHECK FOR LOOSE

FASTENERS AND PARTS

SSpark Plug Boot S Air Filter

S Housing Screws S Handlebar Screws S Debris Shield

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for re- placement of damaged or worn parts.

SON/OFF Switch -- Ensure ON/OFF switch functions properly by moving the switch to the OFF position. Make sure engine stops.

Restart engine and continue

S Fuel Tank -- Discontinue use of unit if fuel tank shows signs of damage or leaks.

S Debris Shield -- Discontinue use of unit if debris shield is damaged.

INSPECT AND CLEAN UNIT AND DECALS

S After each use, inspect complete unit for loose or damaged parts. Clean the unit and decals using a damp cloth with a mild deter- gent.

SWipe off unit with a clean dry cloth.

CLEAN AIR FILTER

A dirty air filter decreases engine performance and increases fuel consumption and harmful emissions. Always clean after every 5 hours of operation.

1.Clean the cover and the area around it to keep dirt from falling into the carburetor chamber when the cover is removed.

2.Remove parts by pressing button to re- lease air filter cover.

NOTE: To avoid creating a fire hazard or pro- ducing harmful evaporative emissions, do not clean filter in gasoline or other flammable sol- vent.

3.Wash the filter in soap and water.

4.Allow filter to dry.

5.Add a few drops of oil to the filter; squeeze the filter to distribute oil.

6.Replace parts making sure the filter is seated completely.

Air Filter

Cover

Screws

Back view of Air Filter Cover

Air Filter

REPLACE SPARK PLUG

Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 in. Ignition timing is fixed and nonadjustable.

1.Twist, then pull off spark plug boot.

2.Remove spark plug from cylinder and dis- card.

3.Replace with Champion RCJ-6Y spark plug and tighten securely with a 3/4 inch socket wrench..

4.Reinstall the spark plug boot.

REPLACING THE LINE

1.Press the tab on the side of the trimmer head and twist the lock ring.

2.Remove the lock ring and tap button.

		Trimmer
		Head
		Tab
Tap Button	Lock Ring

3.Pull spool out of the trimmer head.

4.Clean dirt and debris from all parts.

5.Replace with a pre-wound spool , or re- place line using two 20 feet lengths of 0.080! (2 mm) diameter line.

6.When installing new line on an existing spool, insert 1/16th of the line into the an- choring hole in the bed of the spool, and wrap the line evenly and and firmly around

the spool in the direction of the arrow found on the spool.

Anchoring

Hole

7.Insert ends of the lines through the exit holes in the sides of the trimmer head.

NOTE: A metal insert is located in the exit hole. As your unit wears from use, you can re- install this insert upside down to provide a new surface for the exit of the line from the trimmer head.

12