Weed Eater 530163346 Style A, Style B, NOTE Remove, Know Your Trimmer, On/Stop Switch, Choke

STYLE B

1.Remove washer and wing nut from shield.

2.Assemble parts as shown in illustration.

3.Securely tighten wing nut onto bolt.

Shield

NOTE: Remove	Line Limiter
and use washer and	Blade
wing nut from this	Wing Nut
bolt for assembling
	Washer
shield.

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

STYLE A	Assist Handle			STYLE B
					Assist Handle
			Tube
					Tube
						Trimmer Head
Throttle Trigger		Shield		Throttle
					Shield
				Trigger

Trimmer Head

Line Limiter Blade

Line Limiter Blade

	ON/STOP	Spark Plug
	Switch
Starter Rope
Handle				Choke Lever
					Primer Bulb
			Fuel Mix Fill Cap

ON/STOP SWITCH

The ON/STOP switch is used to stop engine. To stop the engine, push and release the engine ON/STOP switch.

PRIMER BULB

The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.

CHOKE

The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After the engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke lever to the OFF CHOKE position.

4