Elbow
Spacer
Ring
|
|
|
|
|
|
|
|
|
|
Clamp Ring |
| Slot |
| Key | |||||
|
| ||||||||
|
|
|
|
| |||||
4.Align key with slot and insert elbow into blower outlet.
5.Securely tighten the clamp by turning the knob.
6.Proceed to ALL UNITS
SEMBLY.
ELECTRIC UNITS WITH THREADS
1.Stop the motor, disconnect power source, and wait until impeller has completely stopped turning.
2.Remove all tubes or other attach- ments from unit.
3.Remove spacer ring from elbow.
4.Thread the small end of the elbow into the blower outlet until the elbow stop is about 3/8 inch from blower outlet.
5.Proceed to ALL UNITS
SEMBLY.
ELECTRIC UNITS WITH TABS
1.Stop the motor, disconnect power source, and wait until impeller has completely stopped turning.
2.Remove all tubes or other attach- ments from unit.
3.Insert the notched end of the adapter into the elbow tube; push parts to- gether until the adapter snaps into place.
Groove | Notched |
Tab | End |
|
4.Align the grooves on the adapter with the tabs on the blower outlet.
5.Push adapter onto the blower outlet; turn adapter clockwise until parts snap into place.
6.Proceed to ALL UNITS
SEMBLY.
ELECTRIC UNITS WITH TUBE RELEASE BUTTON
1.Stop the motor, disconnect power source, and wait until impeller has completely stopped turning.
2.Remove all tubes or other attach- ments from unit.
3.Insert the notched end of the adapter into elbow; push parts together until the adapter snaps into place.
Notched End
Tube Release
Button Hole for
tube release
button
Blower Outlet Adapter Elbow
4.Align the grooves on the adapter with the grooves on the blower outlet.
5.Push the adapter onto the blower out- let until it snaps into place (adapter is secured by tube release button).
6.Proceed to ALL UNITS
SEMBLY.
ALL UNITS - TUBE ASSEMBLY
1.Push the slotted end of the pivot tube over the elbow until the flange bottoms out in the elbow groove.
NOTE: Be sure flange snaps into groove.
Pivot Tube 
Flange 
Elbow Groove
Elbow
2.Test rotating action of the pivot tube by rotating the pivot tube right and left.
3.Assemble extension tubes up to a to- tal of 4, depending on the height of gutter to be cleaned.
4.Thread nozzle onto the last tube.
