Service and Adjustments, Tiller, Tire Care | Weed Eater WET6500A

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 22)

Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.

•First loosen handle lock lever.

•Handle can be positioned at different settings between “HIGH” and “LOW” positions.

•Retighten handle lock lever securely after adjusting.

HANDLE (HIGH

POSITION)

HANDLE LOCK

LEVER

HANDLE (LOW

POSITION)

FIG. 22

TIRE CARE

CAUTION: When mounting tires, un- less beads are seated,overinﬂation can cause an explosion.

•Maintain 20 PSI (1.4 kg/cm2) of tire pressure. If tire pressures are not equal, tiller will pull to one side.

•Keep tires free of gasoline or oil which can damage rubber.

TO REMOVE WHEEL (See Fig. 23)

•Place blocks under transmission to keep tiller from tipping.

•Remove hairpin clip and clevis pin from wheel.

•Remove wheel and tire.

•Repair tire and reassemble.

CLEVIS PIN

HAIRPIN CLIP

FIG. 23

15

Image 15

Weed Eater WET6500A Service and Adjustments, Tiller, To Adjust Handle Height See Fig, Tire Care, To Remove Wheel See Fig

Contents

Model NO. WET6500A Preparation Safety RulesMaintenance and Storage Training Table of Contents Assembly Tools Required for AssemblyOPERATOR’S Position See Fig Unpacking Carton See Fig Install Handle See Figs , 4, Check Tire Pressure Attach Clutch Cable See FigConnect Shift ROD See Fig Remove Tiller from Crate Meets Ansi Safety Requirements OperationKnow Your Tiller Reverse Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive FORWARD- Wheels ONLY/TINES Stopped ADD Gasoline Before Starting EngineTurning To Transport Tilling Hints To Start Engine See Fig Tine Shear Pins Adjust Wheels for Cultivating See FigsCultivating Maintenance Maintenance ScheduleGeneral Recommendations AIR Filter See Fig Engine Spark Plug CleaningCooling System See Fig Muffler Tire Care Service and AdjustmentsTo Adjust Handle Height See Fig Tiller Tine Replacement See Figs , 25 Ground Drive Belt Adjustment See Fig To Remove Belt Guard See FigTo Replace Ground Drive Belt See Figs To Adjust Carburetor To Adjust Throttle Control Cable See Fig Engine OIL StorageOther Fuel System Troubleshooting Points Tiller - Model Number WET6500A Handle Assembly KEY Part NO. NO. Description MAINFRAME, Left Side MAINFRAME, Right Side Transmission1.95b Tine Shield Tine Assembly Decals Limited Warranty