Weed Eater 952711325, XT110S, SG14, SG10 Service, Storage, Need Assistance?, Replacing The Line

SERVICE

REPLACING THE LINE

SDisconnect unit from the power source. S Remove the spool by firmly pulling on

the tap button.

S Clean entire surface of hub and spool. S Replace with a pre-wound spool, or cut a length of 30 feet of 0.065 diameter WEED EATER brand line. Use of heavi- er line could overload and damage the unit. Never use wire, rope, string, etc., which can break off and become a dan-

gerous missile.

S Insert one end of the line about 1/2 inch (1 cm) into the small slot inside the spool.

Small

Hole

Spool

S Wind the line evenly and tightly onto the spool. Wind in the direction of the arrow found on the spool.

SPush the line into the notch, leaving 3

to 5 inches (7 -- 12 cm) unwound.

S Insert the line into the exit hole in the hub as shown in the illustration.

Line in

Notch

Hub Line exit hole

6

SAlign the notch with the line exit hole. S Push the spool into the hub until it snaps into place, while keeping light

tension on the end of the line.

S Pull on the line extending outside of the hub to release it from the notch; other- wise, the unit will not function properly.

STORAGE

WARNING: Perform the following steps after each use.

SStop the unit and disconnect the power

source when not in use.

SCarry the unit with motor stopped.

S Store the unit so the line limiter blade cannot cause injury.

SStore unit and extension cord indoors

in a high, dry place out of the reach of children. Store unit unplugged.

SStore unit with all guards in place. Posi- tion unit so that any sharp object can- not accidentally cause injury.

NEED ASSISTANCE?

For assistance, or a replacement part call: 1-800-554-6723.

Safety Glasses	952701645
Spool with 30’ line	952701663
50’ coil of bulk line.	952701550
100’ coil of line.	952701533
200’ coil of line.	952701594